Unregistered
|
|||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| PT Discussions Archive Threads that have had no activity for over 6 months from the PT Discussions forum - new threads and replies are not allowed here |
|
|
LinkBack | Thread Tools | Display Modes |
23rd August 2003, 08:27 AM
|
||||
|
||||
Oil Pressure plug
I know there have been several threads dealing with the location of engine block plugs suitable for oil pressure sensor, most recently this one
Has anyone removed one of these? What fitting is it? (does it even have a fitting?)  (The plug in question which I'd like to remove is the one on the airbox side of the block, towards the back, in between the two heater hoses) It looks like it could take one of those Torx type fittings, but its pretty ill defined. Every thing else is all ready installed for the new 3 pod gauge, except this final hookup.....so close, yet so far!  |
|
23rd August 2003, 08:38 AM
|
||||
|
||||
Did you check at HTTP//WWW.ptdoityourself.com ????
Best help site on the net.
__________________
 Give a man a match, and he'll be warm for an hour. Set a man on fire, and he'll be warm for the rest of his life.
|
|
23rd August 2003, 08:39 AM
|
||||
|
||||
|
try this again HTTP://www.ptdoityourself.com
__________________
Give a man a match, and he'll be warm for an hour. Set a man on fire, and he'll be warm for the rest of his life.
|
|
23rd August 2003, 08:40 AM
|
||||
|
||||
|
I can't help you any sorry. I just wanted to wish you luck and also to bump this up so you get some answers.
__________________
2004 Cool Vanilla Touring Edition moonroof, fuzzy dice, betty boop floor mats, chrome antenna, valve stem covers, chrome door spears, oil cap, washer fluid cap, antenna bezel, and shifter bezel, Airaid intake, Chrome sunvisor decals, Teal chrome wire looms, Kustom Kruzr shifter, 3BL "KRUISIN", chrome grill & door pillars, pinstriped, and a Flowmaster exhaust. |
|
23rd August 2003, 10:46 AM
|
||||
|
||||
|
Quote:
|
|
24th August 2003, 08:07 AM
|
||||
|
||||
|
~BUMP~
anyone? |
|
24th August 2003, 08:47 PM
|
||||
|
||||
|
I think you may be able to get it out with an allen wrench , Race & Street used a modified 1/4 " drive extension to remove mine . I didn't think they were torqued in very much as it spun out raher easily.
__________________
'03 EBlue GT 5sp|addco aftermarket front/rear oversize sways|wildfire strut bar| E&G billet grill|color matched: xenon sides/"crusher" ,rear muds,b/c pillars, interior consoles and oem rear spoiler|B&M sport shifter|Mopar STG 1& bov| 6 autometer gauges|tinted front windows/windshield|custom flamed seat covers|"booger" shifter/tranny bushings|psi-fi ppq|3"maxxfab dp,hi-flo cat to 2.5"ATR single exhaust| |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
