Unregistered
|
|||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Accessorizing your PT Cruiser Archive Threads that have had no activity for over 6 months from the Accessorizing forum - new threads and replies are not allowed here |
|
|
LinkBack | Thread Tools | Display Modes |
7th May 2002, 11:13 AM
|
||||
|
||||
Beltline on hood? - Installation Question
I would like to add a chrome beltline to my PT so I bought the chrome stuff from AutoZone. I just not sure about putting it on the edge of the hood under the emblem. I'm afraid it's going to be too close to look good or even touch. I haven't been able to find any pictures of it installed this way. I've also seen some kits where the beltline stops right before it touches the grille. Any suggestions?
Thanks! 
__________________
  
|
|
7th May 2002, 11:37 AM
|
|||
|
|||
I guess it depends on how wide the trim is..if it's only a quarter inch, you can sneek it underneath the emblem..if it's wider than that, though, it'll bump into it. If you could get the ends with points, I'd get those. That way you could end them about half way to the front and that would look real nice..just like chrome trim on early model cars did.
|
|
7th May 2002, 02:56 PM
|
||||
|
||||
|
Hey Jenz, I'm in the middle of doing the same thing! Go to Silly Eagles Cleveland pics
there are a TON of great pics of what looks like a ton of fun ( that I missed!  ) and also several Cruisers with the beltline like your looking for! Good luck, and POST PICS!!! |
|
7th May 2002, 03:19 PM
|
||||
|
||||
|
I've done it on mine. Looks good I think.
__________________
 Heavily Modded Tangerine Dream Crusher
3BL "1BADPT' Stage 1, Mopar duals and BOV, '06 plasatic intake, AMX intake pipe, Keystone Ram air hood, 3 gauge pod, 225/45/17 2-12" Rockford HX2's w/ Rockford Power 1050s amp and 6 monitors |
|
7th May 2002, 06:56 PM
|
||||
|
||||
|
Here's a pic of mine...
__________________
Heavily Modded Tangerine Dream Crusher
3BL "1BADPT' Stage 1, Mopar duals and BOV, '06 plasatic intake, AMX intake pipe, Keystone Ram air hood, 3 gauge pod, 225/45/17 2-12" Rockford HX2's w/ Rockford Power 1050s amp and 6 monitors |
|
7th May 2002, 09:57 PM
|
||||
|
||||
|
Very Nice Black hawk. I have the beltline in the shade shifting colors. I went below the wings too! Good luck on what you decide to do.
__________________
I just don't understand these people and their obsession with their cars! "HPNOTIQ" Wild Style~  
|
|
8th May 2002, 07:43 AM
|
||||
|
||||
|
Quote:
Thanks for the picture. The beltline looks great on your Cruiser! I wish I could find some chrome that was flat not round like the stuff I got at Auto Zone. I think that would make the cuts neater.
__________________
|
|
8th May 2002, 07:54 AM
|
||||
|
||||
|
Quote:
 You can get more info here.
__________________
--JOEM\01 Base Cranberry Cruiser, painted flames by Mayabb's Hot Rods, Keystone Good Hood, PTeazer roll pan, Stull billet grille, Mooneyes '39 "Devil" taillights, Flipen Hood, Hurst shifter, JBA header, AirRaid intake system, PowerAid throttle body spacer, Bassani single exhaust, Wildfire strut bar, Progress lowering springs, Progress sway bars, chrome engine bits, lots of interior chrome and billet stuff. Moon discs, Futura Super Sport tires. 03 Dodge Ram HEMI (345 HP, no waiting) |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
