More Upgrades!
Well after a weekend I'll never forget down in the land of the Psycho PT tuner Bob Stockum, things are looking good!
I spent the weekend destroying Bob's shop, and lived to tell. After 2:30AM evenings, we managed to do almost an entire rebuild of my engine, from the block up.
The meat of what we did was in redoing my head-gasket, swithcing over to the GT intake manifold and valve cover, water-cooling the Turbo center section and swaping out the Crane -10 cams for the more aggressive -14 Turbo grind. A few hours precicely timing in the new cams and we were ready to rock. I also picked up a Phantom Grip and Hurst shifter to boot.....
Unfortunately we ran out of time this weekend, so we never really had a chance to dial in the new setup at all, but over the net few weeks I should get the chance to get her all worked out..... The quest for 350HP continues!!
A big thanks to Screamin' Stockum for putting up with my awful Canadian humor at 2 in the morning, eh!
Brad
(Psssst, Hey Bob, you done with that grinder yet????)
__________________
My last Dyno run -- 255 WHP and 330 ft/lb TQ
* Hahn Turbo * Crower Rods * JE Pistons * Stainless Valves * Ceramic Coatings * Fidanza flywheel * Crane Cams * Crane Sprockets * Blitz BOV * Greddy Profec A * Borla Exhaust * GT Intake * 53mm TB * 320cc Injectors * Cartech FMU * Crane Hi6-Di2/TRC * ClutchMasters Stage IV * Screamin' Stockum Valvejob & Machine work * Starbucks Powered! *
|