Quote:
Originally posted by Popeye
Ok I did a search and found very little, or I didnt search hard enough  ...but I was curious how hard is it to obtain the parts for a rwd conversion, who all has done it, and are there any write-ups? Any help will be greatly appreciated!
CHEERS! 
|
Bob Stockum is looking into doing an AWD conversion in the near future.
How hard is it to obtain parts? Shouldn't be that difficult if you know how to search the "yards" and know what you are looking for.
How hard is it? Depending on your automotive, fabrication, and welding background. It you have extensive experience in all 3 of these fields, you know what you are in for. Factor is a buttload of $$$, and you are well on the way.
Why are you looking into this? What are your goals?
__________________
Fully built HRC Turboed 2.4: Wiseco pistons, T2 rods, Port & Polished head (Bob Special) with oversize Stainless Steel valves, #14 Crane Cams, AF/X UDP, 3" custom downpipe, 3" hi flow exhaust
No balance shafts, Ported GT intake manifold, Bored Throttle Body, 30lb injectors, Water Injected
